10 Things Everyone Hates About Fiat 500 Replacement Key Cost

Fiat 500 Replacement Key Fob

If your remote key fob has stopped working, it's time to replace the battery. If you replace the battery and it doesn't work it could be a problem elsewhere.

At United Locksmith, we specialize in making new keys for classic automobiles. We have all the tools and accessories needed to perform this service.

Dead Coin Battery

A dead battery is the primary cause of your fiat multipla key 500 keyfob not locking or unlocking the doors. The coin cell battery in the key fob is likely to drain quickly when you don't use frequently enough. If your remote began to show signs of weakening like a loss of range, and then stopped working completely it is likely that the battery is dead.

The battery in the key fob is held in place by steel retaining clips. If the clips are not tight, they can create contact problems that will prevent the remote from receiving power. Make use of a flathead screwdriver to break open the retaining clip and remove the old battery. Choose a battery that is the same voltage, size and specifications as the original.

Water exposure can cause the key fob to corrode, or even become damaged. Even a quick bath in soapy, warm water could cause damage where to get a fiat 500x key fob replacement key cut, click here to visit Telegra for free, the chip. It's best to keep your key fob in a dry environment.

Water Damage

Water damage may be the reason for your key fob not working properly. The rubber seals on key fobs prevent them from being damaged by a small drizzle or splash of water. However, it's crucial to keep the locked keys in fiat 500 of your car away from the washing machine, the ocean and pool.

The key fob comes with an electronic chip in it that sends a signal to your car's immobilizer system. The chip allows the 500 to start and lock. If it gets wet, however it will cease to work.

Try cleaning the inside electronics of your keyfob with isopropyl Alcohol or an electronic cleaner to see whether they're still functioning. However, it's best to get a replacement from a dealership instead of trying to fix the key fob that was submerged in salt water.

A replacement fob may cost you a little bit but it's far cheaper than having to have your fiat remote key 500 towed to a dealership and fixed there! Plus, you can do it yourself with the simplest of steps. Make sure you have the correct type of battery before you attempt to open your key fob. This is a job that's much simpler than it appears, and you can find step-by-step directions on the internet for nearly any key fob for cars.

Faulty Chip

The chip that is contained in the key fob communicates with the car's immobiliser unit to ensure the vehicle is able to start when the correct key is used. If the chip is damaged, or corrupted, your car won't start, no matter what you do.

A faulty chip can occur due to several reasons, but most often it is due to water damage or a dead battery. It is best to delegate the repair to a professional locksmith who will be able to replace the chip in a short time and at a reasonable cost.

If your key fob does not work after exposure to clean water from a tap or rain take it off the battery. Wipe down the electronic component using a paper towel. If the key fob isn't working it's most likely to be a damaged chip that must be replaced.

Some people will go to their dealer if they require a new fiat 500 stolen without keys fob. However, this can be a costly option. United Locksmith is the best option for you if want your Fiat key fob replaced at a reasonable cost. We have the tools and expertise needed to repair your Fiat key fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs transmit signals up 50 feet to the vehicle, which can unlock and close the doors (and start the vehicle in case of automatic transmissions). However, there are some things that could cause the fob to cease functioning. This could be due to a dead coin battery, water damage, worn buttons as well as a receiver module problem and signal interference or an electronic chip that has failed.

If the fob was placed in the pocket of someone who has suffered severe trauma (such as being dropped onto the floor or washed in the washing machine), it may not be able to communicate with the Body Control Module (BCM) of the vehicle. The BCM is a security device which will only accept signals from genuine keys.

If this is the case, you will require replacing your fob. A professional locksmith will handle the entire key replacement process including programming a brand new key for your 500. In fact, they can even provide you with a clone key that functions exactly the same as your original fob (and costs a fraction of the price).