A Step-By-Step Guide To Fiat 500 Replacement Key Cost
fiat keys replacement 500 Replacement Key Fob
It might be time to change the battery if the 500 remote key fob isn't working. If you replace the battery, but it isn't working it could be the issue somewhere else.
At United Locksmith, we specialize in making new keys for old automobiles. We have the tools and parts required for this type of service.
Dead Coin Battery
The most common reason your Fiat 500 key fob will not lock or unlock the doors is a dead battery. The key fob comes with an internal battery called a coin cell that can quickly deplete when it isn't used often enough. If your remote started to show signs of weakness like a loss of range and stopped working completely the battery could be dead.
Metal clips keep the battery securely inside the key fob. If the clips are not tight, they can cause contact problems that will prevent your remote from receiving power. Utilizing a small screwdriver, break the retaining clip to take out the battery, and replace it with a brand new one. Make sure to use a battery with the same voltage, size and specifications as the original.
The exposure to water can cause the key fob to corrode or be damaged. Even a small bath in soapy water can harm the electronic chip within. Keep your key fob dry.
Water Damage
If your key fob doesn't work properly, it may be due to water damage. The rubber seals on key fobs prevent them from getting damaged by a slight drizzle or splash of water. However, it is important to keep the car keys away from the washing machine, the ocean, and even the pool.
The key fob comes with an electronic chip that sends a signal to your car's immobilizer system. This is what allows your 500 to start or lock, but should the chip become wet, it's unable to longer work.
If you want to check if your key fob is still functioning, you can clean the internal electronics using isopropyl or electronic cleaner. However, it's recommended to purchase a replacement from a dealer rather than trying to repair the key fob which is submerged in salt water.
While a replacement fob could cost a bit of money, it's far less expensive than paying for your Fiat 500 to be towed to a dealership and fixed! In addition, you can do it yourself in the simplest of steps. Just make sure you have the right battery type before you attempt to open your key fob. This is a job that's much easier than it looks and you can find step-by-step directions online for almost any key fob for cars.
Faulty Chip
The chip located within the spare key for fiat punto car key 500 (www.Stes.tyc.edu.tw) fob communicates to your car's immobiliser unit to make sure the vehicle is only able to start when the correct key is used. If the chip is damaged or corrupted the car won't start regardless of what you do.
Damage to the water or a dead battery are the most frequent causes of defective chips. It is recommended to leave the task to a professional locksmith, who can replace the chip in a short time and at a a reasonable price.
If your key fob does not work after exposure to clean rain or tap water take it off the battery. Wipe down the electronic component using an old towel. If the key fob still doesn't work it's most likely to be a damaged chip that will need to be replaced.
Many people will seek out their dealer when in need of an entirely new fiat doblo van remote key key fob, however this can be a very expensive alternative. United Locksmith is the best option if you would like to have your Fiat keyfob repaired at a reasonable price. We have the tools and experience necessary to fix your fiat panda key fob replacement key fob in a timely and professional manner.
Faulty Receiver Module
Fiat key fobs transmit an electronic signal to the vehicle that can unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. However, there are a few things that could cause the fob to stop working. These include a dead coin battery water damage, worn buttons and a receiver module issue and signal interference, or an electronic chip that is malfunctioning.
If the fob is in a pocket which has suffered severe trauma (such as being dropped on the hard floor or washed in a washing machine) the fob may not be in a position to connect with the Body Control Module (BCM) of the car. The BCM is a security device that can only accept signals from genuine keys.
If this is the case, then you will need to replace your fob. A professional locksmith will handle the entire replacement process including programming a new key for your 500. They can even give you a clone fob that works exactly like the original (and costs less than the price).
