The Most Pervasive Issues With Peugeot 308 Key Fob

Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a bit however it's still attractive. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing drive.

Here at Coded Car Keys we are often asked to replace peugeot 207 key fob not working 308 key fobs. The following tips can aid in solving the issue whether it is constant or intermittent.

Water Damage

If you leave your fob in a puddle or splash it with water while kayaking, swimming canoeing, rafting, or canyoning, it's probably to sustain water damage. Keep your key fob in a dry bag whenever you go outside or engage in activities that could expose it to a lot of water.

You'll also want to make sure that the fob is dry before opening it up and re-using it. If you detect any odors from the fob (such as industrial liquid or windshield washer fluid), this is another indicator that it is submerged.

A circuit board that's wet can cause the battery to lose its charge, or even explode. If you can get your keyfob 308 from the water you need to turn the button side up and shake as much water out as you can prior to opening the casing. Take the battery out, and then wipe the circuit board down using a cotton swab which has been submerged in 90 percent alcohol.

Other reasons your peugeot 3008 key fob not working 308 remote keyless entry system might stop working include the battery of your coin is dead problems with the receiver module, signal interference, or a faulty electronic chip. If none of the above is the cause you can restart the system by removing the 12 voltage battery from the car for 15 mins.

Dead Coin Battery

Peugeot cars come with a remote-start system which allows the driver to start the car from a distance, warming up or cooling down the vehicle prior to entering. This feature is very beneficial particularly in cold winter months. The remote start system can be stopped for a variety of reasons, such as the dead battery in the coin-battery.

A coin-shaped battery located inside the key fob will last a time of between two and four years, based on how often it's used and where it is purchased. The date of use is usually found on the packaging or marked in the manual.

If the key fob is not functioning after exposure to water that is clean then you must remove the battery, then clean the chip using a paper towel and isopropyl alcohol, then dry it completely before replacing it. In case of exposure to salty or soapy water, the chip could be damaged and you'll have to replace the key fob altogether.

If you're not sure the battery is faulty You can test its voltage with an instrument set to the car's voltage range, and connect it to the terminals for minus and plus. If the voltage is lower than 12-13 volts, you need to replace the battery. You can also reset the computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, it's possible the receiver module has been afflicted with a fault. It's the part that transmits an alert to the car when the key fob is activated, that also acts as an immobiliser. It also stops it from starting unless the correct key is in place.

This could be due to a variety of factors including water damage or simply aging. If the electronic chip within your peugeot 3008 key fob programming 308 keyfob is damaged due to dirty tap water it could be because the keyfob was in contact with it. In this case you'll need to remove it apart and thoroughly clean it with isopropyl alcohol or an electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue is not resolved, it is recommended to visit the local peugeot 207 new key expert or locksmith. They'll utilize a diagnostic tool to identify the issue and repair it for you.

It can be a stressful experience to lose your Peugeot car key. A qualified auto locksmith will be able to resolve the issue within minutes. They can cut a new key and then program it into your vehicle, ensuring you can get back out on the road as quickly as possible. Click here to find a local locksmith near you.

Electronic chip malfunctions

The chip in the Peugeot 308 key fob is a critical part in the remote control system. If it is damaged, your car might not start or receive a message stating "anti-theft active". If this occurs, the only way to fix the issue is to replace the key. Luckily, auto locksmiths who are professionals can complete the task within the shortest period of time.

The chip in the chip of your Peugeot 308 key fob can become faulty due to sweat, water damage dirt, or other causes. If your peugeot expert key fob programming key fob has been exposed soapy or dirty water, it needs to be cleaned right away. You can employ a paper towel as well as isopropyl ethanol to clean the electronic component. The battery should then be allowed to completely dry.

Radio interference can cause the key fob to stop functioning. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. It could be caused by poor conditions or objects within the vicinity of the vehicle. If you experience this issue you should visit a Peugeot dealership.

The Peugeot Key Fob 207/308 is very delicate and requires special attention. You should not drop it or throw it around. If you lose it, try to find it as quickly as possible. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first, and then the positive.